Some english pages
The fischertechnik Interfaces and Controller are supported by some language specific Assemblies called FishFace.. with classes and enumerations to operate fischertechnik models connected to an Interface or Controller. They are based on a system conform DLL : umFish.. (written in VC++) in addition some simple classes to operate it from a specific language.
In Addition ftMscLib.DLL and a 32/64bit driver supported by www.fischertechnik.de | downloads must be installed.
If used with Robo Pro v3.0 / Robo Pro Light on the same system firmware v1.21 is requiered.
Look ROBO TX DLLs.
Runs with the older 32 driver supported by www.fischertechnik.de
C# 2005 and higher : CS2005Fish40Setup.EXE.
German page : C# 2005
In addition the german pages : Sprachen Seite
For the ROBO Interface exits a special ROBO Pro - Corner (english).
Last updated : 03.04.2011